CONTACT US
  • Tel/Wechat/Whatsapp:+86-15376502829
  • Fix: +86-537-2350961
  • Email:cs@chinacoalintl.com
  • Address:No. 11, North of Kaiyuan Road, High-tech Zone, Jining City, Shandong Province, China
Position:Home  /  Product Wiki  /  Causes Of Insufficient Stress At Mining Hoist Winch

Causes Of Insufficient Stress At Mining Hoist Winch

Date:2020-03-11     Label:

Mining Hoist Winch

mining winch

winch

Four reasons why Mining Hoist Winch is under-stressed

   1. The oil pump is overheating.

   Causes: ① the oil pump is worn or damaged; ② the viscosity of the oil is too low;

   Elimination method: ① Repair or replace with new one; ② Use hydraulic oil with recommended viscosity.

   2. The oil pump is not turning properly.

   Cause: The electrical wiring is incorrect;

   Elimination method: Correct the rotation direction of the oil pump.

   3. The oil pump speed is too low.

   Cause: The motor is faulty;

   Elimination method: Eliminate the fault.

   4. The Mining Hoist Winch hydraulic station leaks from the high pressure side to the oil return side or the oil cannot pass normally.

   cause:

  ① Insufficient exhaust of proportional relief valve;

  ② The proportional relief valve is not closed, and there are dirt or damaged parts;

  ③ The solenoid valve is dirty or damaged;

  ④ The spool of the direct-acting relief valve is stuck or damaged by dirt;

  ⑤ The valve core of the pressure reducing valve is stuck or damaged by dirt.

Causes Of Insufficient Stress At Mining Hoist Winch

+

+

Please leave a message
skype
message