The operation method of the Underground Mining Scraper Winch in the daily work
1. The Underground Mining Scraper Winch is controlled by a single valve, and the operation is extremely simple. When the ball valve is opened and the air circuit is connected, the air motor starts to work; by adjusting the angle of the handle of the ball valve, the speed of the wire rope can be controlled to meet various work needs, and the operation should run smoothly from slow speed to full speed.
2. The length of the wire rope should be considered that when the rake bucket reaches the end position, the length left on the drum is not less than three turns.Underground Mining Scraper Winch.
3. During use, if any one of the inner gears is braked by the brake belt, the corresponding reel will rotate and wrap the rope to drive the rake bucket to move. Underground Mining Scraper Winch，at this time, the other inner gear is not braked, and its reel is under the active action of the steel rope. It is driven to rotate, and the wire rope is released, the brake belt alternately brakes the inner gear of the working and unloaded drum, and the rake bucket reciprocates to carry out the rake work.
4. Underground Mining Scraper Winch.If the resistance of the rake bucket is too large, the rake bucket can be returned 1-2 meters, and then raked again. If the tie block is too large, or the rake path is uneven, the large block should be blasted or the rake path should be trimmed.
