Learn About The Operation And Use Of The Underground Mining Scraper Winch
1. The Underground Mining Scraper Winchis controlled by a single valve, and the operation is extremely simple. When the ball valve is opened and the air circuit is connected, the air motor starts to work; the speed of the wire rope can be controlled by adjusting the angle of the handle of the ball valve to meet various work needs. When operating the Underground Mining Scraper Winch, it should run smoothly from slow speed to full speed.
2. The length of the wire rope of the Scraper Winchshould be considered when the raking bucket reaches the end position, and the length left on the drum should not be less than three turns.
3. During the use of the Scraper Winch, if any of the inner gears is braked by the brake belt, the corresponding reel will rotate and wrap the rope, which will drive the rake bucket to move. Under the action, it is driven and rotated, the wire rope is released, the brake belt alternately brakes the inner gear of the working and unloaded drum, and the rake bucket reciprocates to carry out the rake work.
4. Mining Scraper Winch,if the resistance of the rake bucket is too large, the rake bucket can be returned 1-2 meters, and then raked again. If the tie block is too large, or the rake path is uneven, the large block should be blasted or the rake path should be trimmed.
